Mail Call & Home Made Varityper Ribbon Shields

The ribbon shield installed on the Varityper 110. Ribbon shield cut & marked for folding I used a hole punch to make the hole the hammer goes through, but if I were to do it right, I’d exactly measure and cut a thinner rectangle that is *just* big enough for the hammer to pass. That would result in absolute smudge protection. Here’s the thin, stamped steel ribbon shield from the Varityper DSG. It’s kinda banged up, so I straightened it and traced it too in case I need to fabricate a replacement. These were considered to be a consumable for the Hammonds and Varitypers, changed as often as ribbons. Nowadays, Hen’s teeth would be easier to find.

Updated: October 7, 2023 — 10:03 am

6 Comments

Add a Comment
  1. I’d been wondering how the type plate makes a clean impression. I guess it doesn’t without the shield?

    1. Yeah, the width of the shuttle carrier means that the ribbon forks have to be like 3″ apart rather than coming to more of a point like on typebar machines. Without the shield, the paper gets slapped repeatedly onto that strip of ribbon, and if it’s really inky, you get a *lot* of smudging, especially on thicker or clay coated stock.

  2. That certainly did the trick!

  3. Nice work!

    Hammonds also used an impression strip. I guess Varitypers don’t.

    1. Huh, not that I know of – it goes hammer slaps paper into ribbon through shield into typeface on shuttle. The shuttle or the hammer could be considered the “platen”, depending on how you look at it. I don’t even know where the impression strip would go on these.

      1. I think that the Impression Strip is intended to relieve some of the wear on the Vulcanized rubber Hammond type shuttles. I have a 1960s Varityper that uses metal type shuttles, and it has no place to hang an Impression Strip, nor have I seen any mention of them in any of the manuals for that machine that I have seen. I don’t know when Varityper switched from rubber to metal type shuttles, but that is when the Impression Strips were abandoned. My 1960s ‘typer requires a ribbon shield, and is set up to use that narrow carbon ribbon that can no longer be found anywhere. However, it can be converted to use a standard width cloth ribbon.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Your post must include a link to this post.

How does this work?
Write a response on your own website and include a link to this post. Then submit your response’s URL here. Your response may appear here after moderation. To update or remove it, edit or delete your original post and submit the same URL again. Learn more about Webmentions.